Power Cable Series Operating Guidance
| 1. Turn on the switch ( Pic2 ) before using the product |
 |
The power cable cannot charge mobile devices and i t is for preventing self-discharge
when the switch is set at “off”.
Set the switch at “on” before using the product to charge your mobile devices.
Please set the switch at “off” when the product is not being used( Pic2) , it can
lower down the self-discharge rate and keep energy for more than 2 years afterbeing
fully charged. |
| |
| 2. Charging power cable from PC |
Connect the input port of the power cable with the USB port of a computer , to
charg e the power cable. The charging indicator will turn red during charging ,
and will turn green when the power cable is fully charged. See Pic 4 . |
| |
| 3. Charging your mobile devices for emergency with the power cable |
3-1. Select the proper connector () for your cell phones or MP3 .
3-2. Connect the connector with the output port of the power cable. Plug the
connector into your mobile device . The power cable will begin to power or charge
your mobile device accordingly . See Pic3.
3-3. If your mobile device could not be recharged, that means the capacity of the
power cable is used up , please re charge it as indicated in Pic 4 . |
| |
| 4 . Charging mobile devices and /or the power cable from PC |
As shown in Pic 4 , a computer can charge the power cable and your cell phones
or MP3 at the same time. Please do the correct connection referring to Step 3.
|
MP Series Operating Guidance
1. Charging Power-Pack
1-1. Charging via Adapter: a complete adapter consists of an adapter ( ) and acable ( ) .Plug the cable into the adapter to assemble the complete adapter.
Please refer to pic2. Insert the output end of the cable into the input port of the power-pack; and plug the adapter into a wall outlet to charge the power-pack.
1-2. Charging via PC: connect the input end of the power-pack with the USB port of a computer with the cable, to realize charging the
power-pack via PC.
1-3. When the power-pack is being charged, the Light(Low) will be lit al through,while the middle light and the Light(Full) will twinkle alternately. When it's fully charged, all the three lights will turn lit.
2. How to use Switch() and preventing self-discharge
2 - 1. Press down the Switch for 2 seconds to turn on or turn off the product.
2 - 2 . Turn on the S witch before using the product to charge your devices.
2 - 3 . Turn off the Switch when the product is not being used. It can lower down the self-discharge rate and keep most of energy for more than 2 years.
3. Checking the capacity and the working status
3 - 1. Turn on the switch( ) to check the remaining power in the product, and you can see Low –-> Full from the Capacity Indicator( ).
3 - 2. The working light (Use) will be lit when the product charge mobile devices.Pic 4 describes the capacity remaining in the product and the working status.
4. Powering and charging your mobile devices
4 - 1. Check the remnant capacity of the power-pack. If the capacity is low, please charge it as indicated in step 1 before proceeding to the following step.
4 - 2. Select the proper connector ( ) for your mobile device.
4 - 3. Do the connection: Connect the connector to the cable, insert the c onnector into your mobile device , and plug the c able into the output port of the power-pack(refer to Pic5) .
4 -4. Once the proper connections have been made, the power-pack will begin to power or charge your mobile device accordingly , the working indicator (Use) will turn on and your device will display that it is being charged.
Note:
If you have a USB cable, with which you can charge your mobile device from computer USB port, you can also charge the device from power-pack with it.
 
|
